Question 1

What size MGP10 rafter do I need?

Accepted Answer

MGP10 rafters are typically supplied in 90×45, 120×45, 140×45, 190×45 and 240×45 mm sections. The correct size for your project depends on the span, spacing and load condition — always confirm against the AS 1684.2 rafter table for your wind classification.

Question 2

What spacing should I use for MGP10 rafters?

Accepted Answer

Rafters are typically installed at 450 or 600 or 900 mm centres in Australian residential construction. Wider centres mean larger sections; narrower centres allow smaller sections or longer spans for the same section.

Question 3

Is MGP10 suitable for rafters under AS 1684?

Accepted Answer

Yes — MGP10 Pine is recognised under AS 1684 for rafters in residential construction. Wind classification, load condition and span all affect the specific section size needed; always size against the official AS 1684.2 (non-cyclonic) or AS 1684.3 (cyclonic) table.

MGP10 rafters span tables (Australia)