Question 1

What size MGP10 bearer do I need?

Accepted Answer

MGP10 bearers are typically supplied in 140×45, 190×45, 240×45, 240×63 and 240×90 mm sections. The correct size for your project depends on the span, spacing and load condition — always confirm against the AS 1684.2 bearer table for your wind classification.

Question 2

What spacing should I use for MGP10 bearers?

Accepted Answer

Bearers are typically installed at 450 or 600 mm centres in Australian residential construction. Wider centres mean larger sections; narrower centres allow smaller sections or longer spans for the same section.

Question 3

Is MGP10 suitable for bearers under AS 1684?

Accepted Answer

Yes — MGP10 Pine is recognised under AS 1684 for bearers in residential construction. Wind classification, load condition and span all affect the specific section size needed; always size against the official AS 1684.2 (non-cyclonic) or AS 1684.3 (cyclonic) table.

MGP10 bearers span tables (Australia)